1)cisco 2921/k9 хочу теигировать vlan идущие на catylist 2960S,,, на коммутаторе перевёл порт в switchport mode trunk, на циске не могу, на бору 3 порта L3, они вообще могут работать в режиме trunk2) Можно ли привезать Vlan на порты L3,, или это бессмысленно.... Вот вывод ?
Interface configuration commands:
aaa Authentication, Authorization and Accounting.
access-expression Build a bridge boolean access expression
arp Set arp type (arpa, probe, snap) or timeout or log
options
backup Modify backup parameters
bandwidth Set bandwidth informational parameter
bfd BFD interface configuration commands
bgp-policy Apply policy propagated by bgp community string
bridge-group Transparent bridging interface parameters
carrier-delay Specify delay for interface transitions
cdp CDP interface subcommands
channel-group Add this interface to an Etherchannel group
clns CLNS interface subcommands
cmns OSI CMNS
custom-queue-list Assign a custom queue list to an interface
cwmp Configure CPE WAN Management Protocol(CWMP) on this
interface
dampening Enable event dampening
default Set a command to its defaults
delay Specify interface throughput delay
description Interface specific description
dot1q dot1q interface configuration commands
dot1x Interface Config Commands for IEEE 802.1X
duplex Configure duplex operation.
eou EAPoUDP Interface Configuration Commands
ethernet Ethernet interface parameters
exit Exit from interface configuration mode
fair-queue Enable Fair Queuing on an Interface
flow-sampler Attach flow sampler to the interface
fpm Attach fpm package group to the interface
glbp Gateway Load Balancing Protocol interface commands
help Description of the interactive help system
hold-queue Set hold queue depth
ip Interface Internet Protocol config commands
iphc-profile Configure IPHC profile
ipv6 IPv6 interface subcommands
isis IS-IS commands
iso-igrp ISO-IGRP interface subcommands
keepalive Enable keepalive
llc2 LLC2 Interface Subcommands
load-interval Specify interval for load calculation for an
interface
logging Configure logging for interface
loopback Configure internal loopback on an interface
mac-address Manually set interface MAC address
macro Command macro
max-reserved-bandwidth Maximum Reservable Bandwidth on an Interface
mls mls interface commands
mop DEC MOP server commands
mtu Set the interface Maximum Transmission Unit (MTU)
netbios Use a defined NETBIOS access list or enable
name-caching
no Negate a command or set its defaults
ntp Configure NTP
pagp PAgP interface subcommands
pppoe pppoe interface subcommands
pppoe-client pppoe client
priority-group Assign a priority group to an interface
random-detect Enable Weighted Random Early Detection (WRED) on an
Interface
rate-limit Rate Limit
routing Per-interface routing configuration
service-policy Configure QoS Service Policy
shutdown Shutdown the selected interface
snapshot Configure snapshot support on the interface
snmp Modify SNMP interface parameters
source Get config from another source
speed Configure speed operation.
standby HSRP interface configuration commands
tarp TARP interface subcommands
timeout Define timeout values for this interface
topology Configure routing topology on the interface
traffic-shape Enable Traffic Shaping on an Interface or
Sub-Interface
transmit-interface Assign a transmit interface to a receive-only
interface
transport-opt Enable Transport Optimization on an Interface or a
Sub-Interface
tx-ring-limit Configure PA level transmit ring limit
vlan-id Process VLAN-encapsulated packets with a specific
VLAN ID
vlan-range Process VLAN-encapsulated packets with a range of
VLAN IDs
vrf VPN Routing/Forwarding parameters on the interface
vrrp VRRP Interface configuration commands
zone-member Apply zone name
|
Вариант для распечатки
(ok) on 23-Ноя-12, 16:45 
