Доброго всем времени суток. Помогите пожалуйста реанимировать железку.
Заранее прошу прощения за большой ЛОГ. Но это для подробного описания.
Есть проблема. Мне принесли не известно откуда cisco 7206 при подключении к которой вижу следующее:

System Bootstrap, Version 12.1(20000710:044039) [nlaw-121E_npeb 117], DEVELOPMENT SOFTWARE
Copyright (c) 1994-2000 by cisco Systems, Inc.
C7200 platform with 524288 Kbytes of main memory

Self decompressing the image : ################ [OK]

%SYS-4-CONFIG_NEWER: Configuration from version 12.3 may not be correctly understood
чC21140-5-NOCARR: FastEthernet0/0 cable/connector problem?
чC21140-5-NOCARR: FastEthernet0/0 cable/connector problem?
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.
Self decompressing the image : ################ [OK]

*** Bus Error (Fetch) Exception ***
Access address = 0x4
PC = 0x80860d84, Cause = 0xc018, Status Reg = 0x34408002

monitor: command "boot" aborted due to exception

System Bootstrap, Version 12.1(20000710:044039) [nlaw-121E_npeb 117], DEVELOPMENT SOFTWARE
Copyright (c) 1994-2000 by cisco Systems, Inc.
C7200 platform with 524288 Kbytes of main memory

string is disk0:c7200-jk9o3s-mz.123-8.T3.bin

Self decompressing the image :################# [OK]

              Restricted Rights Legend

Use, duplication, or disclosure by the Government is
|
           San Jose, California 95134-1706

Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-BOOT-M), Version 12.0(23)S1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Tue 26-Nov-02 17:39 by nmasa
Image text-base: 0x60008960, data-base: 0x60742000

cisco 7206VXR (NPE400) processor with 491520K/32768K bytes of memory.
R7000 CPU at 350Mhz, Implementation 39, Rev 3.2, 256KB L2, 4096KB L3 Cache
6 slot VXR midplane, Version 2.6

Last reset from power-on
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
125K bytes of non-volatile configuration memory.

47040K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
4096K bytes of Flash internal SIMM (Sector size 256K).

Press RETURN to get started!

00:00:04: %SYS-4-CONFIG_NEWER: Configuration from version 12.3 may not be correctly understood
*Feb 27 02:23:39.599: %SYS-5-CONFIG_I: Configured from memory by console
*Feb 27 02:23:39.599: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-BOOT-M), Version 12.0(23)S1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Tue 26-Nov-02 17:39 by nmasa
*Feb 27
Router(boot)>02:23:39.815: %SYS-6-BOOTTIME: Time taken to reboot after reload = 83555 seconds
*Feb 27 02:23:40.971: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
*Feb 27 02:23:41.971: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
*Feb 27 02:23:48.971: чC21140-5-NOCARR: FastEthernet0/0 cable/connector problem?
*Feb 27 02:23:49.971: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to down

%ERR-1-GT64120 (PCI-0): Fatal error, Parity error on slave read

GT=0xB4000000, cause=0x0180E283, mask=0x0ED01F00, real_cause=0x00800200
bus_err_high=0x00000000, bus_err_low=0x00000000, addr_decode_err=0x00000470

GT=0xB4000000: Error Registers
int_main_cause=0x83E28001, int0_main_mask=0x00000FF0, int1_main_mask=0x001FD00E
int_high_cause=0x00000000, int0_high_mask=0x00000000, int1_high_mask=0x001DD000
int0_select   =0x03E00000, int1_select   =0x03E00000
serr0_mask    =0x0000003F, serr1_mask    =0x00000000

ecc_upper_data =0x00000000, ecc_lower_data=0x0E167540
ecc_from_memory=0x00000081, ecc_calculated=0x00000069
ecc_err_report =0x0E167532

%ERR-1-FATAL: Fatal error interrupt, reloading

err_stat=0x1, err_enable=0xFF, mgmt_event=0x40

System bridge dump:

Bridge 0, for PA Bay 0 (I/O Card, PCMCIA, Interfaces), Handle=0
DEC21150 bridge chip, config=0x0
(0x00):dev, vendor id       = 0x00231011
(0x04):status, command      = 0x83B00147
         Detected Parity Error  on primary bus
         Data Parity Detected   on primary bus
(0x08):class code, revid    = 0x06040006
(0x0C):hdr, lat timer, cls  = 0x00012E10
(0x18):sec lat,cls & bus no = 0x18020100
(0x1C):sec status, io base  = 0x02A03101
(0x20):mem base & limit     = 0x48704000
(0x24):prefetch membase/lim = 0x0001FF01
(0x30):io base/lim upper16  = 0x00000000
(0x3C):bridge ctrl          = 0x00030000
(0x40):arb/serr, chip ctrl  = 0x02000000
(0x64):serr disable, gpio   = 0xF0000000
(0x68):sec clk ctrl,serrsta = 0x000001FF

PA bridge dump:

=== Flushing messages (02:29:52 UTC Tue Feb 27 2024) ===

Buffered messages:

00:00:04: %SYS-4-CONFIG_NEWER: Configuration from version 12.3 may not be correctly understood
*Feb 27 02:23:39.599: %SYS-5-CONFIG_I: Configured from memory by console
*Feb 27 02:23:39.599: %SYS-5-RESTART: System restarted --
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-BOOT-M), Version 12.0(23)S1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)
TAC Support: http://www.cisco.com/tac
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Tue 26-Nov-02 17:39 by nmasa
*Feb 27 02:23:39.815: %SYS-6-BOOTTIME: Time taken to reboot after reload = 83555 seconds
*Feb 27 02:23:40.971: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up
*Feb 27 02:23:41.971: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up
*Feb 27 02:23:48.971: чC21140-5-NOCARR: FastEthernet0/0 cable/connector problem?
*Feb 27 02:23:49.971: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to down
*Feb 27 02:29:48.971: чC21140-5-NOCARR: FastEthernet0/0 cable/connector problem?
Queued messages:
*Feb 27 02:29:52.639: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging output.
rnet0/0 cable/connector problem?Free space check for bootflash:crashinfo_20240227-022952 failed (1/9049)

*** System received an Error Interrupt ***
signal= 0x16, code= 0x0, context= 0x60a496b0
PC = 0x603c6198, Cause = 0x2020, Status Reg = 0x34008002

System Bootstrap, Version 12.1(20000710:044039) [nlaw-121E_npeb 117], DEVELOPMENT SOFTWARE
Copyright (c) 1994-2000 by cisco Systems, Inc.
C7200 platform with 524288 Kbytes of main memory

Self decompressing the image : ##################### [OK]

%SYS-4-CONFIG_NEWER: Configuration from version 12.3 may not be correctly understood
чC21140-5-NOCARR: FastEthernet0/0 cable/connector problem?
%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.

чC21140-5-NOCARR: FastEthernet0/0 cable/connector problem?Self decompressing the image : ################ [OK]

              Restricted Rights Legend

Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.

           cisco Systems, Inc.
           170 West Tasman Drive
           San Jose, California 95134-1706

И т.д. по кругу.

На флэшке два ИОСа при выставлении в Rommone любого из них результат не меняется.

rommon 3 > dev
Devices in device table:       id  name
bootflash:  boot flash                    
slot0:  PCMCIA slot 0              
slot1:  PCMCIA slot 1
disk0:  PCMCIA slot 0
disk1:  PCMCIA slot 1
eprom:  eprom

rommon 4 > dir slot0:
Directory of slot0:
    
-rw-     c7200-jk9o3s-mz.123-8.T3.bin    
-rw-     crashinfo_20050303-0911282796    
-rw-     c7200-jk9o3s-mz.123-9a.bin

rommon 5 > boot slot0:c7200-jk9o3s-mz.123-9a.bin и тот же эффект.

Заранее благодарен за ответы.
P.S. Я вообще работаю связистом (SDH, PDH, DWDM), так что эта тема для меня новая, надеюсь на ответы подробные и со всеми нюансами.