qreply - send a message on a stream in the reverse direction
#include <sys/stream.h> void qreply(queue_t *q, mblk_t *mp);
Architecture independent level 1 (DDI/DKI).
q
mp
The qreply() function sends messages in the reverse direction of normal flow. That is, qreply(q, mp) is equivalent to putnext(OTHERQ(q), mp).
The qreply() function can be called from user, interrupt, or kernel context.
Example 1 Canonical Flushing Code for STREAMS Drivers.
This example depicts the canonical flushing code for STREAMS drivers. Assume that the driver has service procedures so that there may be messages on its queues. See srv(9E). Its write-side put procedure handles M_FLUSH messages by first checking the FLUSHW bit in the first byte of the message, then the write queue is flushed (line 8) and the FLUSHW bit is turned off (line 9). See put(9E). If the FLUSHR bit is on, then the read queue is flushed (line 12) and the message is sent back up the read side of the stream with the qreply() function (line 13). If the FLUSHR bit is off, then the message is freed (line 15). See the example for flushq(9F) for the canonical flushing code for modules.
1 xxxwput(q, mp) 2 queue_t *q; 3 mblk_t *mp; 4 { 5 switch(mp->b_datap->db_type) { 6 case M_FLUSH: 7 if (*mp->b_rptr & FLUSHW) { 8 flushq(q, FLUSHALL); 9 *mp->b_rptr &= ~FLUSHW; 10 } 11 if (*mp->b_rptr & FLUSHR) { 12 flushq(RD(q), FLUSHALL); 13 qreply(q, mp); 14 } else { 15 freemsg(mp); 16 } 17 break; . . . 18 } 19 }
put(9E), srv(9E), flushq(9F), OTHERQ(9F), putnext(9F)
Writing Device Drivers
STREAMS Programming Guide
Закладки на сайте Проследить за страницей |
Created 1996-2024 by Maxim Chirkov Добавить, Поддержать, Вебмастеру |