Проект OpenNet: MAN malo (4) Специальные файлы /dev/* (FreeBSD и Linux)

malo (4)

>> malo (4) ( FreeBSD man: Специальные файлы /dev/* )

BSD mandoc

NAME



malo

 - Marvell Libertas IEEE 802.11b/g wireless network driver

To compile this driver into the kernel, place the following lines in your kernel configuration file:

device malo device pci device wlan device firmware

Alternatively, to load the driver as a module at boot time, place the following lines in loader.conf5:

if_malo_load="YES"
wlan_load="YES"
firmware_load="YES"

In both cases, place the following line in loader.conf5 to load the firmware module:

malofw_load="YES"

The driver provides support for Marvell Libertas 88W8335 based PCI network adapters.

This driver requires firmware to be loaded before it will work. These firmware files are from the Ox driver.

A package for the firmware which can be installed via pkg_add1 can be found at:

http://weongyo.org/project/malo/malo-firmware-1.4.tar.gz

This package must be installed before ifconfig(8) will work.

For more information on configuring this device, see ifconfig(8).

The following cards are among those supported by the driver:

Card  Chip    Bus     Standard Netgear WG311v3      88W8335 PCI     b/g
Tenda TWL542P   88W8335 PCI     b/g
U-Khan UW-2054i 88W8335 PCI     b/g

Join an existing BSS network (i.e., connect to an access point):

"ifconfig malo0 inet 192.168.0.20 netmask 0xffffff00"

Join a specific BSS network with network name ``my_net ''

"ifconfig malo0 inet 192.168.0.20 netmask 0xffffff00 ssid my_net"

Join a specific BSS network with WEP encryption:

ifconfig malo0 inet 192.168.0.20 netmask 0xffffff00 ssid my_net \
        wepmode on wepkey 0x8736639624

The device driver first appeared in Fx 8.0 .

Партнёры:

Хостинг: