Интерактивная система просмотра системных руководств (man-ов)
jme (4)
>> jme (4) ( FreeBSD man: Специальные файлы /dev/* )
BSD mandoc
NAME
jme
- JMicron Gigabit/Fast Ethernet driver
SYNOPSIS
To compile this driver into the kernel,
place the following lines in your
kernel configuration file:
device miibusdevice jme
Alternatively, to load the driver as a
module at boot time, place the following line in
loader.conf5:
if_jme_load="YES"
DESCRIPTION
The
device driver provides support for JMicron JMC250 PCI Express
Gigabit Ethernet controllers and JMicron JMC260 PCI Express Fast
Ethernet controllers.
All LOMs supported by the
driver have TCP/UDP/IP checksum offload for both transmit and receive,
TCP segmentation offload (TSO), hardware VLAN tag stripping/insertion
features, Wake On Lan (WOL) and an interrupt coalescing/moderation
mechanism as well as a 64-bit multicast hash filter.
The JMC250 also supports Jumbo Frames (up to 9216 bytes), which can be
configured via the interface MTU setting.
Selecting an MTU larger than 1500 bytes with the
ifconfig(8)
utility configures the adapter to receive and transmit Jumbo Frames.
The
driver supports the following media types:
autoselect
Enable autoselection of the media type and options.
The user can manually override
the autoselected mode by adding media options to
rc.conf5.
10baseT/UTP
Set 10Mbps operation.
100baseTX
Set 100Mbps (Fast Ethernet) operation.
1000baseTX
Set 1000baseTX operation over twisted pair.
The
driver supports the following media options:
full-duplex
Force full duplex operation.
half-duplex
Force half duplex operation.
For more information on configuring this device, see
ifconfig(8).
LOADER TUNABLES
Tunables can be set at the
loader(8)
prompt before booting the kernel or stored in
loader.conf5.
hw.jme.msi_disable
This tunable disables MSI support on the Ethernet hardware.
The default value is 0.
hw.jme.msix_disable
This tunable disables MSI-X support on the Ethernet hardware.
The default value is 0.
SYSCTL VARIABLES
The following variables are available as both
sysctl(8)
variables and
loader(8)
tunables:
dev.jme.%d.tx_coal_to
Maximum amount of time to delay for Tx completion interrupt in
units of 1us.
The accepted range is 1 to 65535, the default is 100 (100us).
dev.jme.%d.tx_coal_pkt
Maximum number of packets to fire Tx completion interrupt.
The accepted range is 1 to 255, the default is 8.
dev.jme.%d.rx_coal_to
Maximum amount of time to delay for Rx completion interrupt in
units of 1us.
The accepted range is 1 to 65535, the default is 100 (100us).
dev.jme.%d.rx_coal_pkt
Maximum number of packets to fire Rx completion interrupt.
The accepted range is 1 to 255, the default is 2.
dev.jme.%d.process_limit
Maximum amount of Rx events to be processed in the event loop before
rescheduling a taskqueue.
The accepted range is 10 to 255, the default value is 128 events.
The interface does not need to be brought down and up again before
a change takes effect.
