Интерактивная система просмотра системных руководств (man-ов)
if_bfe (4)
>> if_bfe (4) ( FreeBSD man: Специальные файлы /dev/* )
BSD mandoc
NAME
bfe
- Broadcom BCM4401 Ethernet Device Driver
SYNOPSIS
To compile this driver into the kernel,
place the following lines in your
kernel configuration file:
device miibus
device bfe
Alternatively, to load the driver as a
module at boot time, place the following line in
loader.conf5:
if_bfe_load="YES"
DESCRIPTION
The
driver provides support for Broadcom BCM4401 based Fast Ethernet adapters.
The
driver supports the following media types:
- autoselect
-
Enable autoselection of the media type and options.
- 10baseT/UTP
-
Set 10Mbps operation.
- 100baseTX
-
Set 100Mbps (Fast Ethernet) operation.
The
driver supports the following media options:
- full-duplex
-
Set full duplex operation.
For further information on configuring this device, see
ifconfig(8).
DIAGNOSTICS
- "bfe%d: couldn't map memory"
-
A fatal initialization error has occurred.
- "bfe%d: couldn't map interrupt"
-
A fatal initialization error has occurred.
- "bfe%d: failed to allocate DMA resources"
-
There are not enough mbufs available for allocation.
- "bfe%d: watchdog timeout -- resetting"
-
The device has stopped responding to the network, or there is a problem with
the network connection (cable).
SEE ALSO
altq(4),
arp(4),
miibus(4),
netintro(4),
ng_ether4,
ifconfig(8)
HISTORY
The
device driver first appeared in
Fx 5.1 .
AUTHORS
An -nosplit
The
device driver was written by
An Stuart Walsh
and
An Duncan Barclay .
This manual page was written by
An Stuart Walsh .
Index
- NAME
-
- SYNOPSIS
-
- DESCRIPTION
-
- DIAGNOSTICS
-
- SEE ALSO
-
- HISTORY
-
- AUTHORS
-
