modload - load a kernel module
modload [-p] [-e exec_file] filename
The modload command loads the loadable module filename into the running system.
filename is an object file produced by ld -r. If filename is an absolute pathname then the file specified by that absolute path is loaded. If filename does not begin with a slash (/), then the path to load filename is relative to the current directory unless the -p option is specified.
The kernel's modpath variable can be set using the /etc/system file. The default value of the kernel's modpath variable is set to the path where the operating system was loaded. Typically this is /kernel /usr/kernel.
For example, the following command looks for ./drv/foo:
example# modload drv/foo
The following command looks for /kernel/drv/foo and then /usr/kernel/drv/foo:
example# modload -p drv/foo
The following options are supported:
-e exec_file
-p
See attributes(5) for descriptions of the following attributes:
|
ld(1), add_drv(1M), kernel(1M), modinfo(1M), modunload(1M), system(4), attributes(5), modldrv(9S), modlinkage(9S), modlstrmod(9S), module_info(9S)
Use add_drv(1M) to add device drivers, not modload. See for procedures on adding device drivers.
Закладки на сайте Проследить за страницей |
Created 1996-2024 by Maxim Chirkov Добавить, Поддержать, Вебмастеру |