Greg Page <greg@caldera.com
of Caldera Incorporated has written
a suite of IPX configuration tools and enhanced the Linux IPX kernel support.
The kernel enhancements allow linux to be configured as a fully featured IPX bridge or router. The enhanced IPX support has already been fed back into the mainstream kernel distribution so you will probably already have it.
The network configuration tools provide you with the capability to configure your network devices to support IPX and allow you to configure IPX routing and other facilities under Linux. The Linux IPX network tools are available from: sunsite.unc.edu.
This command is used to manually add, delete or check
ipx capability to an existing network device. Normally the network device
would be an Ethernet device such at eth0
. At least one IPX interface
must be designated the primary interface and the -p flag
to this command does this. For example to enable Ethernet device eth0
for IPX capability as the primary IPX interface using the IEEE 802.2 frame type
and IPX network address 39ab0222
you would use:
# ipx_interface add -p eth0 802.2 0x39ab0222
If the frame type differs from NetWare(tm) servers on this network, they will studiously ignore you. If the frame type is correct but the network number differs, they will still ignore you but complain frequently on the NetWare server console. The latter is guaranteed to gain you flames from your NetWare administrator and may disrupt existing NetWare clients.
If you get an error while running this program and you happen to not
have already configured tcp/ip, then you will find that you need to manually
start the eth0
interface using the command:
# ifconfig eth0 up
This command enables or disables the automatic setting of the interface configuration and primary interface settings.
--auto_interface
allows you to select whether new network devices should be automatically configured as IPX devices or not.
--auto_primary
allows you to select whether the IPX software should automatically select a primary interface or not. Problems have been noted using this with Windows 95 clients on the network.
# ipx_configure --auto_interface=on --auto_primary=on
This command allows you to configure or deconfigure
an internal network address. An internal network address is optional, but when
it is configured it will always be the primary interface. To configure an
IPX network address of ab000000
on IPX node 1
you would use:
# ipx_internal_net add 0xab000000 1
The command allows you to manually modify the IPX routing
table. For example to add a route to IPX network 39ab0222
via
a router with node number 00608CC33C0F
on IPX network
39ab0108
:
# ipx_route add 0x39ab0222 0x39ab0108 0x00608CC33C0F
Закладки на сайте Проследить за страницей |
Created 1996-2024 by Maxim Chirkov Добавить, Поддержать, Вебмастеру |