>show int vlan 101
>show vlan id 101
>show int po1 trunk
>дай вывод на обоих коммутаторах? На 3750:
#sh int vlan 101
Vlan101 is up, line protocol is up
Hardware is EtherSVI, address is 0018.7319.2c44 (bia 0018.7319.2c44)
Internet address is 10.0.1.2/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 1000 bits/sec, 2 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
8899 packets input, 1047563 bytes, 0 no buffer
Received 0 broadcasts (202 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
1589 packets output, 147445 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
***
show vlan id 101
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
101 VLAN0101 active Fa1/0/1, Fa1/0/3, Fa1/0/11
Fa1/0/12, Po1
VLAN Type SAID MTU Parent RingNo BridgeNo Stp BrdgMode Trans1 Trans2
---- ----- ---------- ----- ------ ------ -------- ---- -------- ------ ------
101 enet 100101 1500 - - - - - 0 0
Remote SPAN VLAN
----------------
Disabled
Primary Secondary Type Ports
------- --------- ----------------- ------------------------------------------
***
Newcom3750#show int po1 trunk
Port Mode Encapsulation Status Native vlan
Po1 on 802.1q trunking 1
Port Vlans allowed on trunk
Po1 1-4094
Port Vlans allowed and active in management domain
Po1 1,6,10,100-105,110-111,192,1001
Port Vlans in spanning tree forwarding state and not pruned
Po1 1,6,10,100-105,110-111,192,1001
На 2960 щас выдать не могу, ибо ехать туда надо, а отседа доступа нету.